What is the correct sequence of steps for removing and installing the LDP pump? Disconnect the LDP electrical connector. Carefully remove the vapor...

The correct sequence of steps for removing and installing the LDP pump is as follows: 1. Disconnect the LDP electrical connector. 2. Carefully remove the vapor and vacuum ducts from the LDP. 3. Remove the 3 LDP installation bolts. 4. Remove the LDP from inside the fender. 5. Install the LDP assembly inside the fender. Install the 3 bolts and tighten them to a torque of 2 N·m (20 lbs. in.). 6. Carefully install the vapor and vacuum ducts on the LDP and the LDP filter. The vapor and vacuum ducts and hoses must be firmly connected. Check the vapor and vacuum ducts on the LDP, the LDP filter, and the VAP chamber cleaning solenoid for damage. If there is a leak, a fault diagnostic code (DTC) may be established. 7. Connect the electrical connector to the LDP. 8. Install the air cleaner box. Refer to air cleaner box, resonator, and ducts removal and installation. Remember to follow the manufacturer's instructions and take all necessary safety precautions when working with automotive components.