Buscar

What is the correct sequence of steps for disassembling and assembling the pitman shaft, joints, and bearings? Disassemble the short shaft box and ...

What is the correct sequence of steps for disassembling and assembling the pitman shaft, joints, and bearings?
Disassemble the short shaft box and remove the O-rings.
Remove the pitman shaft joint, joints, and bearings.
Clean the exposed end of the pitman shaft and the box with a wire brush.
Install the upper pitman shaft bearing with the 8294 insert and the C-4171 handle.
Install the lower pitman shaft bearing with the 8294 insert and the C-4171 handle.
Cover the oil seal and support washers with the special grease supplied with the new seal.
Install the oil seal using the 8294 insert and the C-4171 handle.
Install the plastic support washers.
Install the metal support washer.
Install the retaining ring using spring ring pliers.
Cover the dust seal with the special grease supplied with the new seal.

a. 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11
b. 3, 1, 2, 4, 5, 6, 7, 8, 9, 10, 11
c. 2, 1, 3, 4, 5, 6, 7, 8, 9, 10, 11

Essa pergunta também está no material:

011 - Direccion Asistida Nafta
30 pág.

Livros OutrosOutros

💡 1 Resposta

User badge image

Ed Verified user icon

A sequência correta de etapas para desmontar e montar o eixo do pitman, juntas e rolamentos é a seguinte: 1. Desmonte a caixa do eixo curto e remova as O-rings. 2. Remova a junta do eixo do pitman, juntas e rolamentos. 3. Limpe a extremidade exposta do eixo do pitman e a caixa com uma escova de arame. 4. Instale o rolamento superior do eixo do pitman com o inserto 8294 e a alça C-4171. 5. Instale o rolamento inferior do eixo do pitman com o inserto 8294 e a alça C-4171. 6. Cubra a vedação de óleo e as arruelas de suporte com a graxa especial fornecida com a nova vedação. 7. Instale a vedação de óleo usando o inserto 8294 e a alça C-4171. 8. Instale as arruelas de suporte de plástico. 9. Instale a arruela de suporte de metal. 10. Instale o anel de retenção usando alicate de anel de pressão. 11. Cubra a vedação de poeira com a graxa especial fornecida com a nova vedação. A sequência correta de etapas é a alternativa c) 2, 1, 3, 4, 5, 6, 7, 8, 9, 10, 11.

0
Dislike0

✏️ Responder

SetasNegritoItálicoSublinhadoTachadoCitaçãoCódigoLista numeradaLista com marcadoresSubscritoSobrescritoDiminuir recuoAumentar recuoCor da fonteCor de fundoAlinhamentoLimparInserir linkImagemFórmula

Para escrever sua resposta aqui, entre ou crie uma conta

User badge image

Outros materiais