To remove and install the generator, follow these steps: Removal: Step 1: Remove the battery. Step 2: Remove the battery tray. Step 3: Remove the sensor from the battery tray and disconnect the engine wiring harness. Step 4: Remove the sensor from the battery tray. Installation: Step 1: Place the sensor in the installation hole and secure the wiring harness. Step 2: Press the sensor into the top of the battery tray. Step 3: Install the battery. To install the generator: Step 1: Place the generator on the engine and install the installation bolts. Step 2: Tighten the installation bolts with a torque wrench. Step 3: Connect the 2-wire field connector to the back of the generator. Step 4: Attach the protective cover of the B (+) installation stud cable. Step 5: Install the generator transmission belt. Step 6: Install the negative battery cable on the battery. Remember to follow the manufacturer's instructions and refer to the specific vehicle's manual for any additional steps or precautions.
Para escrever sua resposta aqui, entre ou crie uma conta
Compartilhar