For the usual installation of decorative beams in the ceiling, what is the correct procedure?

I- Make a hole in the center of the piece if the sup...

Question

For the usual installation of decorative beams in the ceiling, what is the correct procedure?

I- Make a hole in the center of the piece if the supplied supports do not have one.
II- Mark the path of the beam on the ceiling.
III- Insert a Fischer plug and screw the supports.
IV- Cut the beam to the necessary size and nail it on each side.
a) I, II, III, IV
b) I, II, IV, III
c) II, I, III, IV

Ed · Answer

Para a instalação usual de vigas decorativas no teto, o procedimento correto é:

I- Fazer um furo no centro da peça se os suportes fornecidos não tiverem um.
II- Marcar o caminho da viga no teto.
III- Inserir uma bucha Fischer e parafusar os suportes.
IV- Cortar a viga no tamanho necessário e pregá-la em cada lado.

Portanto, a sequência correta é a alternativa: c) II, I, III, IV.

For the usual installation of decorative beams in the ceiling, what is the correct procedure? I- Make a hole in the center of the piece if the sup...

Cursos Online

Colégio Objetivo

Essa pergunta também está no material:

Como instalar vigas decorativas

Cursos Online • AgráriasAgrárias

Respostas

Responda

Mais conteúdos dessa disciplina

Perguntas dessa disciplina

What are the materials and tools needed for the installation of decorative beams? Herramientas: lápiz, martillo, escalera, brocas de widia, brocas ...

What is the function of the sensor shown in the illustration? I - Detect the rotation speed of the power shaft of the transmission. II - Detect th...

What is the purpose of the tool for developing motor control units? The tool helps to increase the number of sensors and actuators in the car. The...

What is the function of the sensor NE in the gasoline engine control system? I - The NE signal is used to detect the crankshaft angle and engine s...

Conteúdos escolhidos para você

Etno02

Etno03

Etnomatematica01